JENFAB (4) Stage Pass Thru Parts Washer 12” Belt Engineered to clean light parts Manufactured in 2012

JENFAB (4)Stage Pass Thru Parts Washer 12” Belt Engineered to clean light parts Manufactured in 2012 Custom Designed to wash light parts. Includes Higher Side Guides on Belt Approx 3.5”. Custom 12” wide compact grid belting for both top and bottom belts. This Belt Washer Aqueous Parts Washer is designed to clean parts by directing spray impingement and volume of solution delivery at components as they are positioned and travel along a conveying belt through wash, rinse, rinse/or rp, and dry zone. Spays are located above and below the belt. General Specifications: Work Area 12” Wide Belt 3.5” Variable Height ” High Maximum Part Clearance (waiting to confirm) Stages: 18” Load 6” Enter 30” Wash Length 9” Drain 18” Rinse Length 6” Drain 18” Rinse Length 6” Drain 45” Blow-Off Ari Knives Above and Below Parts with Regenerative Blower 200 Deg. Max 34-1/8” Unload 140 Deg. F. Maximum Wash Temperature Tanks: Insulation Process Tanks Stainless Steel Pumps In Each Tank 1HP Gould 110 Gallon Wash Tank 75 Gallon Rinse Tank 75 Gallon Rinse Tank Fitting Added to rinse tank to RP Tank can counterflow to the rinse tank in the future. AIR BLOW OFF: Vortex 15 HP Regenerative BLower Dimensions: 174” L x 48” W x 72”T Equipped With: Variable Speed Drive 7-14 Feet Per minute Digital Controls all three tanks Shop Air Blow Off at the end and in between wash and rinse Stainless Plumbing Electric Heat 22.5KW Wash, 12KW Rinse, 12KW Inhibit Stainless Pumps Gusher 1 HP 460 Volt 3 Ph 60 HZ 115 FLA Smart Automatic Water Level SS Float Switches in each tank, water added through brass solenoid valves. Fresh Water is added to the RP Tank , RP water is added to the rinse tank. Rinse water is added to the wash tank. Temperature Controlled by digital controllers in each tank and the dryer. UL Control Panel 304 SS Steel FOB, Tulsa, OK