JENFAB (4) Stage Pass Thru Parts Washer 12” Belt Engineered to clean light parts Manufactured in 2012

JENFAB (4)Stage Pass Thru Parts Washer 12” Belt Engineered to clean light parts
Manufactured in 2012

Custom Designed to wash light parts. Includes Higher Side Guides on Belt Approx 3.5”. Custom 12” wide compact grid belting for both top and bottom belts.

This Belt Washer Aqueous Parts Washer is designed to clean parts by directing spray impingement and volume of solution delivery at components as they are positioned and travel along a conveying belt through wash, rinse, rinse/or rp, and dry zone. Spays are located above and below the belt.

General Specifications:

Work Area

12” Wide Belt
3.5” Variable Height ” High Maximum Part Clearance (waiting to confirm)
Stages:

18” Load
6” Enter
30” Wash Length
9” Drain
18” Rinse Length
6” Drain
18” Rinse Length
6” Drain
45” Blow-Off Ari Knives Above and Below Parts with Regenerative Blower 200 Deg. Max
34-1/8” Unload
140 Deg. F. Maximum Wash Temperature
Tanks:

Insulation Process Tanks
Stainless Steel Pumps In Each Tank 1HP Gould
110 Gallon Wash Tank
75 Gallon Rinse Tank
75 Gallon Rinse Tank
Fitting Added to rinse tank to RP Tank can counterflow to the rinse tank in the future.
AIR BLOW OFF:

Vortex 15 HP Regenerative BLower
Dimensions:

174” L x 48” W x 72”T
Equipped With:

Variable Speed Drive 7-14 Feet Per minute
Digital Controls all three tanks
Shop Air Blow Off at the end and in between wash and rinse
Stainless Plumbing
Electric Heat 22.5KW Wash, 12KW Rinse, 12KW Inhibit
Stainless Pumps Gusher 1 HP
460 Volt 3 Ph 60 HZ 115 FLA
Smart Automatic Water Level SS Float Switches in each tank, water added through brass solenoid valves. Fresh Water is added to the RP Tank , RP water is added to the rinse tank. Rinse water is added to the wash tank.
Temperature Controlled by digital controllers in each tank and the dryer.
UL Control Panel
304 SS Steel
FOB, Tulsa, OK